VLL Services Command Reference
Page 246 7705 SAR OS Services Guide
bundle-id: bundle-type-slot-id/mda-slot.bundle-num
bundle-id value range: 1 to 10
For example:
*A:ALU-12>config# port bundle-ppp-5/1.1
*A:ALU-12>config>port# multilink-bundle
qtag1 — specifies the encapsulation value used to identify the SAP on the port or sub-port. If this
parameter is not specificially defined, the default value is 0.
Values qtag1: 0 to 4094
The values depend on the encapsulation type configured for the interface.
Table 33 describes the
allowed values for the port and encapsulation types.
create — keyword used to create a SAP instance. The create keyword requirement can be
enabled/disabled in the environment>create context.
mac
Syntax [no] mac ieee-address
Context config>service>ipipe>sap
Description This command assigns a specific MAC address to an Ipipe Ethernet SAP.
The no form of this command returns the MAC address of the SAP to the default value.
Default The default is the physical MAC address associated with the Ethernet interface where the SAP is
configured.
Parameters ieee-address — specifies the 48-bit MAC address in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff
where aa, bb, cc, dd, ee, and ff are hexadecimal numbers
Table 33: Port and Encapsulation Values
Port Type Encap-Type Allowed Values Comments
Ethernet Null — The SAP is identified by the port.
Ethernet Dot1q 0 to 4094 The SAP is identified by the 802.1Q tag on the port. Note that a
0 qtag1 value also accepts untagged packets on the dot1q port.
To Next Page
Loading...
