VLL Services
7705 SAR OS Services Guide Page 225
Re-enabling a Service
Use the no shutdown command to re-enable a previously disabled VLL service. The
following CLI syntax displays the command to re-enable an Apipe service. Use a similar
syntax to re-enable Cpipe, Epipe, and Ipipe services.
CLI Syntax: config>service#
apipe service-id
no shutdown
PE router 1 (A:ALU-41):
Example: A:ALU-41>config>service# apipe 5
A:ALU-41>config>service>apipe# no shutdown
A:ALU-41>config>service>apipe# exit
PE router 2 (A:ALU-42):
Example: A:ALU-42>config>service# apipe 5
A:ALU-42>config>service>apipe# no shutdown
A:ALU-42>config>service>apipe# exit
Deleting a Service
Use the shutdown command to delete a VLL service. The SAP, and any associated
protocols and spoke SDPs, must be deleted from the VLL service before the VLL service
can be deleted.
Perform the following steps to delete a service:
1. Shut down the SAP and SDP.
2. Delete the SAP and SDP.
3. Shut down the service.
To Next Page
Loading...
