Alcatel-Lucent 7705 - Configuring Apipe SAP Parameters

VLL Services
7705 SAR OS Services Guide Page 201
Configuring Apipe SAP Parameters
Use the following CLI syntax to configure Apipe SAP parameters. For ingress and egress
configuration information, see Configuring Ingress and Egress SAP Parameters on page
217.
CLI Syntax: config>service# apipe service-id [customer customer-id]
[create] [vpn vpn-id] [vc-type {atm-vcc|atm-vpc}] [vc-switching]
sap sap-id [create]
accounting-policy acct-policy-id
atm
egress
traffic-desc traffic-desc-profile-id
ingress
traffic-desc traffic-desc-profile-id
oam
alarm-cells
collect-stats
description description-string
egress
qos policy-id
ingress
qos policy-id
no shutdown
Example: A:ALU-41>config>service# apipe 5
A:ALU-41>config>service>apipe# sap 1/1/1.1:0/32 create
A:ALU-41>config>service>apipe>sap# ingress
A:ALU-41>config>service>apipe>sap>ingress# qos 102
A:ALU-41>config>service>apipe>sap>ingress# exit
A:ALU-41>config>service>apipe>sap# egress
A:ALU-41>config>service>apipe>sap>egress# qos 103
A:ALU-41>config>service>apipe>sap>egress# exit
A:ALU-41>config>service>apipe>sap# no shutdown
A:ALU-41>config>service>apipe>sap# exit
A:ALU-41>config>service>apipe#