Alcatel-Lucent 7705 - Applying ETH-CFM Parameters

Services Overview
7705 SAR OS Services Guide Page 97
Applying ETH-CFM Parameters
Apply ETH-CFM parameters to the following entities, as shown in the CLI syntax examples
below:
•Epipe SAP
• Epipe spoke SDP
• OAM tests (loopback, linktrace, Ethernet test, delay measurement, loss
measurement)
The MAC address for a MEP on an Epipe cannot be changed. For a MEP on a SAP, the
MAC address is the port MAC address. For a MEP on a spoke SDP, the MAC address is the
system MAC address.
In Release 3.0, the 7705 SAR supports the following MEPs:
• 802.1ag
→ SAP Up MEP
→ SAP Down MEP
→ spoke SDP Down MEP
•Y.1731
→ SAP Up MEP
→ SAP Down MEP
CLI Syntax: config>service>epipe>sap
eth-cfm
mep mep-id domain md-index association ma-index
[direction {up|down}]
ccm-enable
ais-enable
ccm-ltm-priority priority
eth-test-enable
low-priority-defect {allDef|macRemErrXcon|
remErrXcon|errXcon|xcon|noXcon}
[no] shutdown