Alcatel-Lucent 7705 - Installing Components; Warnings and Notes; CSM

ETH-CFM (802.1ag and Y.1731) Tasks
Page 96 7705 SAR OS Services Guide
exit
exit
----------------------------------------------
Y.1731 Configuration
The following example displays a Y.1731 configuration. The first set of commands occurs at
the global level. The second set occurs at the Epipe service level.
*A:ALU-1>config>eth-cfm# info
----------------------------------------------
domain 1 format none level 1
association 1 format icc-based name "1234567890123"
bridge-identifier 100
exit
ccm-interval 1
exit
exit
----------------------------------------------
*A:ALU-1>config>service>epipe# info
----------------------------------------------
shutdown
sap 2/2/1:40 create
eth-cfm
mep 1 domain 1 association 1 direction up
ais-enable
priority 2
interval 60
exit
eth-test-enable
test-pattern all-ones crc-enable
exit
no shutdown
exit
exit
exit
no shutdown
...
----------------------------------------------
Note: RDI information is carried in the CCM OAMPDU. To be able to transmit and also
receive RDI information, a MEP must have CCM enabled. See
Applying ETH-CFM
Parameters
.
Note: To be able to transmit and also receive AIS PDUs, a Y.1731 MEP must have ais-
enable set. To be able to transmit and also receive ETH-Test PDUs, a Y.1731 MEP must
have eth-test-enable set.