Alcatel-Lucent 7705 - Configuring PW Redundancy - Standby Signaling

Configuring VLL Components
Page 220 7705 SAR OS Services Guide
Configuring PW Redundancy – Standby Signaling
For standby signaling, create an endpoint as shown in the preceding section, but specify an
SDP as the standby signaling master (in the following example, precedence 1 indicates that
the spoke SDP is the standby SDP).
CLI Syntax: config>service# cpipe service-id [customer customer-id]
[create]
endpoint endpoint-name [create]
standby-signaling-master
exit
spoke-sdp sdp-id:vc-id endpoint endpoint-name
[create]
precedence precedence-value
no shutdown
Example: config>service cpipe 2100
config>service>cpipe# endpoint “Endpoint_Y” create
config>service>cpipe>endpoint# standby-signaling-master
config>service>cpipe# spoke-sdp 1:100 endpoint
“Endpoint_Y” create
config>service>cpipe>spoke-sdp$ precedence primary
exit
config>service>cpipe# spoke-sdp 2:200 endpoint
“Endpoint_Y” create
config>service>cpipe>spoke-sdp$ precedence 1
exit