VLL Services Command Reference
Page 302 7705 SAR OS Services Guide
903 201:903 Spok 131061 131065
904 401:904 Spok 131060 131063
-------------------------------------------------------------------------------
Number of Bindings Found : 19
-------------------------------------------------------------------------------
id
Syntax id service-id
Context show>service
Description This command displays information for a particular service-id.
Parameters service-id — identifies the service in the domain
ingress-label
Syntax ingress-label start-label [end-label]
Context show>service
Description This command displays services using the range of ingress labels.
If only the mandatory start-label parameter is specified, only services using the specified label are
displayed.
If both start-label and end-label parameters are specified, the services using this range of labels are
displayed.
Use the show router vprn-service-id ldp bindings command to display dynamic labels.
Table 36: Show Service Egress Label Output Fields
Label Description
Svc Id Identifies the service
Sdp Binding Identifies the SDP
Type Specifies the SDP binding type (for example, spoke)
I. Lbl Displays the VC label used by the far-end device to send packets to this
device in this service by the SDP
E. Lbl Displays the VC label used by this device to send packets to the far-end
device in this service by the SDP
Number of
bindings found
Indicates the total number of SDP bindings that exist within the
specified egress label range
To Next Page
Loading...
