Alcatel-Lucent 7705 - Table 40: Service-ID SAP Output Fields

VLL Services Command Reference
Page 308 7705 SAR OS Services Guide
Ingress TD Profile : 1 Egress TD Profile : 1
Alarm Cell Handling: Enabled
OAM Termination : Disabled Periodic Loopback : Disabled
===============================================================================
*A:ALU-12>show>service>id#
Table 40: Service-ID SAP Output Fields
Label Description
Service Access Points
Service Id Identifies the service
SAP Specifies the ID of the access port where this SAP is defined
Encap Specifies the encapsulation type for this SAP on the access port
Admin State Specifies the desired state of the SAP
Oper State Specifies the operating state of the SAP
Flags Specifies the conditions that affect the operating status of this SAP
Display output includes SeviceAdminDown, PortOperDown, and so
on
Last Status Change Specifies the date and time of the most recent status change to this
SAP
Last Mgmt Change Specifies the date and time of the most recent management-initiated
change to this SAP
Dot1Q Ethertype Identifies the value of the dot1q Ethertype
LLF Admin State Specifies the Link Loss Forwarding administrative state
LLF Oper State Specifies the Link Loss Forwarding operational state
Admin MTU Specifies the desired largest service frame size (in octets) that can be
transmitted through this SAP to the far-end router, without requiring
the packet to be fragmented
Oper MTU Specifies the actual largest service frame size (in octets) that can be
transmitted through this SAP to the far-end router, without requiring
the packet to be fragmented
Ingr IP Fltr-Id Specifies the ingress IP filter policy ID assigned to the SAP
Egr IP Fltr-Id Specifies the egress IP filter policy ID assigned to the SAP
Ingr Mac Fltr-Id Specifies the ingress MAC filter policy ID assigned to the SAP