VLL Services Command Reference
Page 266 7705 SAR OS Services Guide
ce-address
Syntax ce-address ip-address
no ce-address
Context config>service>ipipe>sap
config>service>ipipe>spoke-sdp
Description This command specifies the IP address of the CE device associated with an Ipipe SAP or spoke SDP.
In the case of a SAP, it is the address of the CE device directly attached to the SAP. For a spoke SDP,
it is the address of the CE device reachable through that spoke SDP (for example, attached to the SAP
on the remote node). The address must be a host address (no subnet addresses are accepted) as there
must be only one CE device attached to an Ipipe SAP. The CE address specified at one end of an
Ipipe will be used in processing ARP messages at the other endpoint, as the router acts as a proxy for
ARP messages.
Default none
Parameters ip-address — specifies the IP address of the CE device associated with an Ipipe SAP
control-word
Syntax control-word
no control-word
Context config>service>apipe>spoke-sdp
config>service>cpipe>spoke-sdp
config>service>epipe>spoke-sdp
config>service>ipipe>spoke-sdp
Description This command indicates whether the control word is used or not. The value of the control word is
negotiated with the peer.
This command is mandatory for SAToP and CESoPSN encapsulation.
.
To Next Page
Loading...
