VLL Services Command Reference
Page 268 7705 SAR OS Services Guide
Parameters cell-count — specifies the maximum number of ATM cells to be accumulated in an MPLS packet
before queuing the packet for transmission onto the pseudowire
Values 1 to 29
Default 29
max-delay
Syntax max-delay delay-time
no max-delay [delay-time]
Context config>service>apipe>spoke-sdp>cell-concatenation
Description This command enables the configuration of the maximum amount of time to wait while performing
ATM cell concatenation into an MPLS packet before transmitting the MPLS packet. This places an
upper bound on the amount of delay introduced by the concatenation process. When this amount of
time is reached from when the first ATM cell for this MPLS packet was received, the MPLS packet is
queued for transmission onto the pseudowire.
The no form of this command resets max-delay to its default value.
Parameters delay-time — specifies the maximum amount of time, in hundreds of microseconds, to wait before
transmitting the MPLS packet with whatever ATM cells have been received. For example, a
value of 1 equals 100 μs, and a value of 400 equals 40000 μs, or 40 ms.
Values 1 to 400
Default 400
To Next Page
Loading...
