Internet Enhanced Service
7705 SAR OS Services Guide Page 365
Values sap-id:atm[port-id][:vpi/vci | vpi]
IMA group [bundle-id][:vpi/vci | vpi]
port-id slot/mda/port[.channel]
bundle-type-slot/mda.bundle-num
bundle keyword
type ima
bundle-num 1 to 10
vpi NNI 0 to 4095
UNI 0 to 255
vci 1, 2, 5 to 65535
port-id — specifies the physical port ID in the slot/mda/port format
If the card in the slot has a T1/E1 ASAP Adapter card installed, the port-id must be in the
slot_number/MDA_number/port_number format. For example 1/2/3 specifies port 3 on MDA 2
in slot 1.
The port-id must reference a valid port type. When the port-id parameter represents TDM
channels, the port ID must include the channel ID. A period “.” separates the physical port from
the channel-id. The port must be configured as an access port.
bundle-id — specifies the multilink bundle to be associated with this IP interface. The bundle
keyword must be entered at the beginning of the parameter. The command syntax must be
configured as follows:
bundle-id: bundle-type-slot-id/mda-slot.bundle-num
bundle-id value range: 1 to 10
For example:
*A:ALU-12>config# port bundle-ppp-5/1.1
*A:ALU-12>config>port# multilink-bundle
create — keyword used to create a SAP instance. The create keyword requirement can be
enabled/disabled in the environment>create context.
ingress
Syntax ingress
Context config>service>ies>interface>sap
Description This command enables access to the context to associate ingress filter policies with the SAP.
If an ingress filter is not defined, no filtering is performed.
To Next Page
Loading...
