VPRN Services Command Reference
Page 456 7705 SAR OS Services Guide
ip-int-name | ip-address — the name of the IP interface or IP address. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
Values ip-int-name: up to 32 alphanumeric characters
ip-address: a.b.c.d
spoke-sdp
Syntax [no] spoke-sdp sdp-id
Context config>service>vprn
Description This command binds a service to an existing Service Distribution Point (SDP).
The SDP has an operational state that determines the operational state of the SDP within the service.
For example, if the SDP is administratively or operationally down, the SDP for the service will be
down.
The SDP must already be defined in the config>service>sdp context in order to associate an SDP
with a VPRN service. If the sdp sdp-id is not already configured, an error message is generated. If the
sdp-id exists, a binding between that sdp-id and the service is created.
SDPs must be explicitly associated and bound to a service. If an SDP is not bound to a service, no
far-end routers can participate in the service. Alternatively, auto-bind can be used. With auto-bind,
no vprn>spoke-sdp configuration is required. When both auto-bind and spoke-sdp are configured,
spoke-sdp takes precedence. Spoke-sdp must be deconfigured for auto-bind to take effect.
The no form of this command removes the SDP binding from the service. The SDP configuration is
not affected; only the binding of the SDP to a service is affected. Once the SDP is removed, no
packets are forwarded to the far-end router.
Default none
Special Cases
VPRN — several SDPs can be bound to a VPRN service. Each SDP must be destined for a different
7705 SAR, 7750 SR, or 7710 SR router. If two sdp-id bindings terminate on the same 7705 SAR,
an error occurs and the second SDP binding is rejected.
Parameters sdp-id — the SDP identifier
Values 1 to 17407
To Next Page
Loading...
