Chapter 4 – Configuration
14 GROUPS
Group setup allows the user to monitor voltage and current circuit information via local interface or the
Monitoring screen at the web interface operation.
It is not possible to monitor circuits that are not included in either group.
To add new groups fill in the following:
The IDENTIFIER text field allows user to enter a single code for the group being defined (maximum 12
characters). No editing allowed;
The IDENTIFIER field shows all the circuits and channels previously configured;
The TYPE field shows the circuits type;
The check box allows user to include the preset circuits for the group formation;
The <DESELECT ALL> button allows user to deselect all circuits marked;
The <SELECT ALL> button allows user to select all circuits;
The LENGTH, R0, X0, R1 and X1 text fields allow user to enter the transmission line characteristics
(length and impedance), for the fault location.
Once the group is created, it shows in the configuration interface menu. When selecting the group, a screen
shows its characteristics, as shown in the figure below. It is possible to edit all the fields.
Figure 39: Adding and editing a group
A The <REMOVE> button allows user to delete the group.
To Next Page
Loading...