Chapter 14 – Communications
6 COMMUNICATION THROUGH NETWORK USING THE SERIAL
PORT
Communication via modem is a Dial-in access method, but in cases of automatic connection via modem, the
connection is permanent and is automatically started by the equipment.
For communication through network using the serial port, it is first necessary to make a pre-configuration of
the computer, as following:
1. Access the Control Panel of the computer;
2. On the Control Panel, access the Network Connection icon, and then access File New Connection
Connect to Internet;
3. Select the Set up my connection manually check box and then, click on the Next button;
4. Select the Connect using a dial-up modem check box and then, click on the Next button;
5. Insert a connection name and click on the Next button;
6. Insert a phone number to dial and click on the Next button;
7. Enter a username and password. The default username and password to connect via modem, that
cannot be changed by the user, are:
Default username and password to connect via modem
8. Then, click on the Finish button to end the configuration.
To access the Web Interface of the RPV-311, verify the Server IP Address of the connection properties and
then, enter this IP address in the web browser.
Application to Access the Equipment
The equipment can be accessed through the Web Interface using a web browser. Please note that some
applications may need to be installed and the minimum computer requirements should be met.
To Next Page
Loading...