Alstom Reason RPV311 - Equipment Log

Appendix A – Equipment Log
RPV311
RPV311-TM-EN-6
341
1 EQUIPMENT LOG
The equipment log contains information about:
 Threshold violations, fault and disturbance triggers and data recording;
 Data record transfer (including the IP address to which data has been transferred);
 Access to the unit's configuration pages (including IP address of which the access was performed);
 Alarms and the results of auto-diagnosis routines;
 Power-up and shutdown.
The equipment log cannot be erased by the user. Its capacity is enough for approximately 5 years of typical
use, with past events being erased if memory space is needed.
Log
Description
Cause
000
Internal failure
Hardware or processing failure
001
Invalid key
The key applied to the equipment is not valid
010
Power up
Equipment power-up
011
Power off
Equipment power-off
012
Auto power-off (primary power failure)
Battery operated power time run-out
013
Emergency power-off (low battery)
Battery charge below expected, equipment
shut off automatically
020
Primary power OK
Primary power supply voltage equipment
021
Primary power NOK
Battery backup equipment
029
Battery status [value: ]
Battery voltage indication
030
Temperature normal [value: ]
Temperature return to normal values
031
Temperature high [value: ]
Internal temperature high
039
Temperature status [value: ]
Equipment temperature indication
050
Equipment ready
Equipment normal operation
051
Equipment not ready
Equipment is not operational
100
IRIG-B signal
Equipment is connected to IRIG-B signal