Alstom Reason RPV311 - Equipment Identification

RPV311
Chapter 4 – Configuration
RPV311-TM-EN-6
61
3 EQUIPMENT
3.1 IDENTIFICATION
On this screen, shown below, it is possible to configure the equipment identifier, location and owner.
These three fields make up the equipment file name pursuant to the COMNAME rule.
The equipment identification will appear in the name of the records; therefore, it is very important that it be
properly identified. The name format of the records is:
date,hour,location,identifier,owner...
Figure 9: Equipment identification configuration section
A The IDENTIFIER text field allows user to enter an equipment code (maximum 12 characters).
B The LOCATION text field allows user to enter a substation code (maximum 12 alphanumeric characters,  ,
 , 0 , 0-9 , a-z , A-Z)
C The OWNER text field allows user to enter the name of the company which purchased the equipment
(maximum 12 characters).