Figure 89: Device window
There are two parameters to be configured by the user:
Enable Auto COMTRADE Download: When enabled, the unit will be part of the Auto Polling process,
where records not yet saved are automatically downloaded.
Enable Auto Refreshing: When enabled, the unit will be part of the process of Auto Refresh, where the
equipment state will be updated automatically during the process.
The user can change the equipment host address, and enable or disable the "Enable Auto COMTRADE
Download" and "Enable Auto Refreshing". At the end of the editing, the software automatically
communicates with the equipment in order to upgrade the name and location information.
If the equipment is associated with any transmission, a message will be shown to the user at the beginning
of the Edit.
After the closing the ‘Device’ window, the equipment updates are registered.
Transmission Lines (Automatic Fault Location)
The transmission line window configures the parameters necessary to execute the Traveling Wave Fault
Location algorithm on the TW high acquisition frequency records.
On this menu the user can view the list of the registered lines, add, edit, or remove any transmission line.
To Next Page
Loading...