Alstom Reason RPV311 - Figure 41: Relay Signaling Events Configuration Section

RPV311
Chapter 4 – Configuration
RPV311-TM-EN-6
107
Figure 41: Relay signaling events configuration section
A The LOG events text field allows user to enter a code used for signaling events. Refer to Chapter 5 for log
references. Signaling is only during the time set in the previous section.
B The WARNINGS check box allows user to select the following events for signaling:
 Equipment not ready;
 Primary power failure;
 Temperature high;
 Equipment unsync;
 Fault recorder lack of memory;
 Disturbance recorder lack of memory;
 Steady-state recorder lack of memory;
 SOE recorder lack of memory;
 Link communication failure;
 Internal failure.
In this case, signaling is active while the problem that has generated the alarm is not resolved.