TW Fault Locator software’s buttons
The <HOME> button displays the graphic in the format of the initial display
The <BACK> and <FORWARD> allow the zoom graph to navigate the front and rear positions
The <PAN> button allows manual dressing of the graphic
The <ZOOM> button allows selection of the area of the graph to enlarge
The <SAVE> button allow saving in an image file
The information presented for each of the records is:
Date and time stamp of the record beginning;
Terminal identification;
Voltage values of the phases A, B and C at the moment when the cursor is positioned;
Time stamp when the cursor is positioned.
It is possible to only one open window graphics for viewing. If the viewer is open and runs a new location for
another set of records it is necessary to close the preview window and open it again.
After manually setting the times of the wave fronts, it is possible to use the LOCATE BY CHART button to
find the fault, of the time stamps marked on the graph.
While the fault location algorithm is running, no other time stamps can be selected.
The graphical tool can also be used to confirm the results of automatic fault location.
If the user provides the tower’s geographic coordinates in the .tw file, the program enables the KML
button. Click on this button and a KML file is created to be viewed on Google Earth. In addition, the
geographic coordinates of the fault are shown on the graphic interface.
2.5 GOOSE CONFIGURATOR
2.5.1 DESCRIPTION
The GOOSE Configurator is an application that combines elements of a configuration GOOSE message file
of the IED with the digital channels of the RPV.
The software allows the user to receive, edit, and transmit a configuration of the RPV.
2.5.2 INTERFACE
When installing the RPV Tools, it creates a desktop icon for quick access. The configuration interface can be
accessed directly via this icon.
To access the configuration interface, do the following:
To Next Page
Loading...