Chapter 4 – Configuration
To enable thresholds individually, click on the threshold and select ENABLE;
To disable discarded thresholds individually, click on the threshold and select DISABLE;
To break or remove complex thresholds, click on the threshold and select CUT LAST;
To create equations with AND operators, follow the procedures below:
o Click on the threshold and select CUT LAST;
o Click on the threshold to which is desired to add the previously selected threshold and then
select the threshold to be added.
D Selecting the RECEIVE ETHERNET CROSS-TRIGGER or SEND ETHERNET CROSS-TRIGGER check box enables
these features. It allows the start of the recording of an exceeded threshold by Ethernet cross-trigger.
E The <SELECT QUANTITY> button allows user to select the derived quantity of triggered disturbance records.
If the quantities are not manually selected, the record will consist of all the quantities available for
measurement.
11.2 CONTINUOUS RECORDING
In this section, shown in Figure 34, it is possible to configure the equipment's continuous recorder.
Figure 34: Disturbance recorder – continuous recording configuration section
To Next Page
Loading...