Chapter 4 – Configuration
10 FAULT RECORDER
The RPV311 allows user to register triggered and continuous fault recorder.
10.1 TRIGGER’D RECORDING
In this section, shown in Figure 31, it is possible to configure the equipment's fault triggered recorder.
Figure 31: Fault recorder – triggered recording configuration section
A The ENABLED check box allows user to enable the fault recorder feature.
B The PRE TIME text field allows user to enter the recording time before the event in seconds. The POST TIME
text field allows user to enter the recording time after the event in seconds. The TIME OUT text field allows
user to enter the maximum time in seconds, where the event will be recorded. The DISABLED FOR – MINUTES
IF MORE THAN – TRIGGERS IN THE LAST – SECONDS allows user to disable recorder if the event repeats within a
programmed time period.
To Next Page
Loading...