Chapter 14 – Communications
7.3 COMMUNICATION CONFIGURATION
It is possible to configure the communication ports (Ethernet, Gateway and Modem) of the RPV311 in the
Web Interface. For communication configuration details, refer to Chapter 4.
7.4 AUTO UPLOAD
When any new record is generated, it can be transmitted to up to two different servers automatically. When
using the configuration interface, each destination IP address should be entered, along with the designated
record type.
If at the upload time the server is not available or the network is unreadable, the record will not be
transmitted. Within such case, it is always advisable to use the application Scanner or the RPV Manager to
For further Scanner application information see Chapter 12.
For further RPV Manager application information see Chapter 13.
For auto upload configuration details, see Chapter 4.
To Next Page
Loading...