Chapter 4 – Configuration
15 RELAYS
Relays indicate events or state transitions and set off the alarm on the equipment. RPV311 provides four
relays: three relays set by the user and one factory default relay, which signals internal equipment failure.
15.1 ON TIME
In this section, shown in Figure 40, it is possible to configure the relays on time for logging signaling events.
Figure 40: Relays on time configuration section
A The TIME scroll box allows user to select the relays on time for logging signaling events (1 to 10 seconds).
15.2 RELAYS 2, 3, AND 4
In this section, shown in Figure 41, it is possible to configure the relay signaling events.
To Next Page
Loading...