Chapter 4 – Configuration
Figure 19: Record management configuration section
A Selecting the AUTO ERASE check box, erases older record automatically if memory capacity exceeds 90%.
B The ERASE ALL scroll box allows user to choose a type of record (fault, disturbance, steady-state and SOE)
to be removed.
C The <EXECUTE> button allows user to erase all the records on the list.
For details about the memory capacity of each record type, see Chapter 6 Records.
3.9 AUTO UPLOAD
3.9.1 RECORDS
It is possible to send a record to two different servers. In the configuration interface it is possible to configure
the IP address of each destination server and the type of record which will be sent. When a new record is
generated and the record type is enabled for auto upload, it is automatically transmitted to the servers.
If at the upload time the server is not available or the network is unreadable, the record is not retransmitted.
In this case, the record will be transmitted only through the automatic scanning by the server.
The automatic upload of records is a process in which the records are transferred to the server in advance.
To ensure that all the records are stored in the server, it is necessary that the server perform the scanning
process periodically. The records that have already been transmitted to the server are not retransmitted.
In the section shown in Figure 20, it is possible to automatically upload records to a preset destination.
To Next Page
Loading...