Chapter 14 – Communications
Given the following IP address, broadcast and netmask of the RPV311:
IP address, broadcast and netmask of the RPV311
Set the local connection as follows:
IP address, broadcast and netmask of the local connection
If the equipment is not with the default IP settings, see Chapter 5 to see how to check the current IP address.
After connecting the equipment with the computer, see Chapter 4 for details about equipment access.
Note:
Process Bus Ethernet port is used only to receive data of merging units (Sampled Values
measured on monitored Power System). It is not possible to communicate to this RPV311
using that Ethernet port for s their purposes.
4.1 CHECKING THE CONNECTION
In order to verify whether the equipment connection is correctly set up, connect a crossover network cable
between the computer and the equipment and, using a command line terminal, run a ping command to the IP
address of the equipment.
To Next Page
Loading...