Chapter 4 – Configuration
3.3 COMMUNICATIONS
The RPV311 communication may be via Ethernet and serial ports. The equipment may also operate as a
gateway over a local subnet.
Optionally the user can choose between two types of Ethernet, optical and electrical.
Gateway setup will enable the RPV311 to communicate with other equipment connected over a local
subnetwork. The Gateway can be configured by accessing the equipment gateway configuration section,
shown in Figure 10.
Figure 10: Equipment Ethernet configuration section
A The IP text field allows user to enter the equipment's IP address.
B The NETWORK MASK text field allows user to enter the subnetwork mask to which the equipment is
connected.
C The BROADCAST text field allows user to enter the sub network broadcast address to which the equipment
is connected.
D The IP text field allows user to enter the equipment's IP address.
E The PORT scroll box allows user to select the communication port of the equipment used as gateway.
Ethernet 1 and Ethernet 2 can be configured.
The Ethernet port enables the RPV to connect to the TCP / IP / UDP / IP networks.
To Next Page
Loading...