Chapter 4 – Configuration
In Spontaneous mode the RPV sends the PMU data automatically up to 4 different socket addresses (IP +
port number). The 4 streams of data can be sent using unicast or multicast transmission.
The parameters of the Communication screen are listed below:
<COMMANDED> Sets the respective streams of data to Commanded mode.
<SPONTANEOUS> Sets the respective streams of data to Spontaneous mode.
<UNICAST> Sets the addressing of the respective streams of data to Unicast mode. This kind of transmission
connects to a single IP address and the routing of the messages though the available Ethernet ports are
managed by the RPV system. It is important that the destination IP and the RPV311 share the same
subnetwork address.
<MULTICAST> Sets the addressing of the respective streams of data to Multicast mode. This mode required
the user to choose which Ethernet interface the RPV shall use to convey the data.
To Next Page
Loading...