For Use in Safety
9
ML-5120A
Do not splash water on the Laser.
Water splashed over the electric parts, can cause electric shock and short circuits.
Use proper tools (wire strippers, pressure wire connectors, etc.) for
termination of the connecting cables.
Do not cut the wire conductor. A re or electric shock will occur.
Install the Laser on a rm and level surface.
If the Laser falls or drops, injury may result.
Do not place a water container on the Laser.
If water spills, insulation of the Laser will deteriorate, and that can cause
electric leaks and re.
Keep combustible matter away from the Laser.
Surface ash and expulsion can ignite combustible matter. If it is impossible
to remove all combustible matter, cover it with non-combustible material.
Do not apply the laser beam to combustible materials.
To avoid risk of re never apply the laser beam to ammable or
combustible materials.
Do not cover the Laser with a blanket, cloth, etc.
Do not cover the Laser with a blanket, cloth, etc. while you are using it.
The cover may be overheated and burn.
Do not use this Laser for purposes other than metal processing.
Use of the Laser in a manner other than specied can cause electric shock
and re.
Protective gear must be worn.
Put on protective gear such as protective gloves, long-sleeve jacket, leather
apron, etc. Surface ash and expulsion can burn the skin if they touch the skin.
Keep a re extinguisher nearby.
Keep a re extinguisher in the processing shop in case of re.
Maintain and inspect the Laser periodically.
Maintain and inspect the Laser periodically, and repair any damage before
starting operation.
CAUTION
To Next Page
Loading...
Need help?
General