86 Intellex
®
LT Digital Video Management System
Port Address Setup
PORT ADDRESS
SETUP
In the Port Address setup screen you may specify a fixed port
address for the Intellex unit to use for connecting to a network. The
default settings are 5000 for the Communications Port and 5001 for
the Live Video Port. Unless instructed otherwise by your IS
administrator, you should accept these settings, as they correspond
to the default settings in the Network Client software. If you do
change port address assignments, they will take effect only after the
unit is restarted.
See the Connecting Network Client with the Remote Intellex Unit
section in the Network Client Installation & Operating Instructions for
details on configuring the Network Client software to
communicate with your Intellex unit.
To Next Page
Loading...
