Installation and Operating Instructions 19
Time Zone Settings
TIME ZONE
SETTINGS
You must configure the unit for operation in your time zone. The
unit will keep track of daylight savings time, if applicable.
To configure the time zone:
NOTE: Do NOT change any other time settings or you may affect
unit operation. Refer to Date/Time Setup on page 84 for
information about setting the system date and time.
1. From the Control Panel screen, double-click the Date/Time
icon. The Date/Time Properties screen appears.
2. Select the Time Zone tab. The Time Zone tab of the
Date/Time Properties screen appears.
3. Click down arrow to display a list of time zones.
Since the list of time zones is too long for the display area, a
scroll bar appears along the right side, with arrows at the top
and bottom and a slide button between.
Use the scroll bar to display time zones that are hidden. Click
up arrow or down arrow, or drag the scroll button up or down.
4. When you locate the correct time zone, select it. The list
disappears and the time zone name is displayed in the box.
5. The system can also Automatically adjust clock for
daylight saving changes. Click the checkbox to select
(check) or de-select (un-check) this option.
6. Select OK to accept the new time zone, close this screen and
return to the Control Panel screen. Select Cancel to close this
screen without changing the time zone and return to the
Control Panel screen.
To Next Page
Loading...
