78 Intellex
®
LT Digital Video Management System
Alarms Setup
ALARMS SETUP
The Alarms Setup screens let you configure alarm operation for the
unit. You must possess the Setup Alarms privilege to access it (see
Security Setup on page 39).
1. From the main screen, click the Setup button. The Setup
Options screen appears (see Setup Options Screen on page 29).
2. Click the Alarm button. The General screen (the first Alarm
Setup screen) appears.
Use the General screen to configure how the unit responds to an
alarm.
NOTE: The virtual keyboard is disabled on the General screen.
Duration — Use this option to set the minimum alarm time (in
minutes and seconds) from five seconds (00:05) to five minutes
(05:00). The unit maintains the active alarm for the set time and
then clears it automatically. The default is five seconds (00:05).
1. Click the minutes display. Click up arrow or down arrow to
display the desired number of minutes.
2. Click the seconds display. Click up arrow or down arrow to
display the desired number of seconds.
Rate — Select the record rate in ips (images per second) when an
alarm occurs. The actual record rate is affected by the number of
cameras, motion and other factors. The default is 30 ips (25 ips
PAL).
1. Click down arrow. A list of record rates appears.
2. Click the desired record rate.
Alarm on Video Loss — Use this option to generate an alarm
event any time the unit stops receiving a video signal from any
camera. The unit also displays the message Video Loss over a color
bar pattern. This option is selected by default. If not selected, the
unit does not respond to loss of camera video.
Alarm Message Display — Use this option to display the message
ALARM on the associated camera’s image whenever an alarm
occurs. This option is selected by default. Otherwise, the alarm
message will not be displayed.
To Next Page
Loading...
