iv Intellex
®
LT Digital Video Management System
License Information
LICENSE
INFORMATION
WARNING: TO REDUCE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
DO NOT INSTALL THIS PRODUCT IN HAZARDOUS AREAS WHERE HIGHLY
COMBUSTIBLE OR EXPLOSIVE PRODUCTS ARE STORED OR USED.
The lightning flash/arrowhead symbol, within an equilateral triangle, alerts the
user to the presence of a shock hazard within the product’s enclosure.
CAUTION:Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the battery
manufacturer. Dispose of used batteries according to the battery manufacturer’s
instructions.
RACK MOUNTING:
Make sure that units are installed to get enough air flow for safe operation.
The maximum temperature for rack-mounted units is 40° C.
Avoid uneven loading or mechanical instability when rack-mounting units.
Check product label for power supply requirements to assure that no overloading
of supply circuits or overcurrent protection occurs.
Mains grounding must be reliable and uncompromised by any connections.
WARNING: This equipment has been tested and found to comply with the limits
for a Class “A” digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at their own expense.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This product was FCC verified under test conditions that included the use
of shielded I/O cables and connectors between system components. To be in
compliance with FCC regulations, the user must use shielded cables and
connectors for all except power and alarm cables.
This digital apparatus does not exceed the Class A limits for radio noise
emissions as set out in the Radio Interference Regulations (ICES-003) of the
Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant
les limites applicables de la Classe A prescrites dans le Réglement (ICES-003)
sur le brouillage radioélectrique édicté par le Ministère des Communications du
Canada.
N205
2
eprüfte
Sicherheit
To Next Page
Loading...
