Installation and Operating Instructions 47
Schedule Setup
Start night at — Use this option to set the start time for nighttime
processing in 24-hour format. The default is 18:00 (6:00 p.m.).
1. Click the hours display. Click up arrow or down arrow to
display the desired hour (24-hour format).
2. Click the minutes display. Click up arrow or down arrow to
display the desired minutes (30-minute increments).
Select another Regular Schedule Setup Option for configuration.
Otherwise, click OK to accept the new start times, as well as any
changes on the other Regular Schedule Setup screens, and return to
the Setup Options screen. Click Cancel to cancel the changes and
return to the Setup Options screen. Click Help to display online
help for this screen.
Regular Cameras Setup Use the Cameras 1–8 and Cameras 9–16 screens to configure a live
filter for each camera, one for daytime and one for nighttime
operation. If you configure a filter and activity is detected (for
example, motion in the target area of the motion detection filter),
the unit records images from the camera at the record rate specified
in the Alarm Setup screens.
Cameras — All camera names are listed down the left side of the
screen in camera order.
NOTE: Before you can configure a live filter, you must record at
least one image from the camera. Until an image is
recorded, the filter options are disabled.
Day Filter — Use this option to select a live filter for this camera
during daytime operation. The default is None.
1. Click down arrow. A list of filters appears.
2. Click the desired filter. Select None to disable any previously
configured filters.
3. Click Setup to configure the filter (see Setup below).
Night Filter — Use this option to select a filter for this camera
during nighttime operation. The default is None.
1. Click down arrow. A list of filters appears.
2. Click the desired filter. Select None to disable any previously
configured filters.
To Next Page
Loading...
