Installation and Operating Instructions 101
Controlling Image Display
To change the screen format:
1. Click the right mouse button. The Image Area Popup menu
appears.
2. Select Mode. The unit displays a list of screen modes: Single,
2x2, 3x3, 4x4.
3. Select the desired screen format. The unit immediately
changes the image area.
To return to the normal screen:
Right-click the mouse and select Switch to Menu to exit full-screen
mode and display the controls and indicators again (see Switch to
Menu on page 99).
Camera Sequencing
The unit can display cameras sequentially in any available format.
Cameras display in camera number order at the Live Display
Sequencer Dwell rate (see Display Setup on page 82).
In the single-pane format, the unit displays images from each
camera in camera order.
In multi-pane formats, cameras appear in their assigned locations.
Cameras without assigned locations appear sequentially in the
lower right window.
NOTE: Sequencing stops when an alarm occurs. You must
acknowledge the alarm before you can start camera
sequencing again. If you do nothing, sequencing
resumes as soon as the unit clears the alarm (see Alarm
Operations on page 141).
To start camera sequencing:
1. Select the screen format: 1x1, 2x2, 3x3 or 4x4.
2. Click the Seq button. The unit switches cameras in the lower
right window (or full-screen) at the Live Display Sequencer
Dwell rate.
To stop camera sequencing:
To Next Page
Loading...
