68 Intellex
®
LT Digital Video Management System
Schedule Setup
Select another segment for configuration. Otherwise, click OK to
accept the configuration for this segment as shown, and return to
the Weekday, Weekend or Holiday screen. Click Cancel to cancel
the changes and return to the Weekday, Weekend or Holiday screen.
Click Help to display online help for this screen.
Live Filter Configuration
NOTE: Before following any procedures in this section, select the
live filter and click Setup (see Regular Cameras Setup on
page 47, Configuring an Active Segment on page 64 and
Configuring an Alarmed Segment on page 66).
After you select a live filter, use the appropriate filter configuration
screen to configure it. This section describes how to configure each
of the following live filters:
•Light Change
• Motion Detection
• Perimeter Protection
Light Change Use the Light Change screen to configure the target area for the light
change filter. Once configured, the filter is triggered whenever the
light level changes. The light level can change when someone turns
lights on or off, uses a flashlight or blocks the camera lens.
After you select the Light Change filter and click the Setup button,
the Light Change screen appears.
Light Change: (camera name) — Indicates the camera name.
Image Area — This area of the screen displays a camera image and
provides a reference when configuring the filter.
Active Zone — The active zone is the area in which the filter’s
targets are activated. It can be nearly any shape or size.
Restore — Click to restore the active zone to its dimensions
when you first accessed this screen.
Clear — Click to erase all of the targets in the active zone.
Sensitivity — The unit uses this setting to distinguish between
valid and invalid changes in the target area. At higher settings,
small changes trigger the filter. At lower settings, larger changes are
required to trigger the filter.
To Next Page
Loading...
