Installation and Operating Instructions 67
Schedule Setup
Normal — Record images at normal image quality. This
setting provides a balance between compression and storage
space requirements.
Extended Record — Record images at the highest level of
compression. This setting requires the lowest amount of
storage space.
Pre-Alarm Sensitivity — This setting lets you control how
Intellex responds to small, subtle changes between images. Select
the sensitivity to use when storing pre-alarm images. The default is
Normal.
High — At this setting, Intellex records the smaller changes
between images, improving the perceived picture quality. As a
result, this setting requires more storage space.
Normal — At this setting, Intellex ignores the smaller, more
subtle changes between images.
Live Filter — Use this option to select the live filter to use during
this segment. When the live filter is activated, the unit switches to
alarm mode. The default is None.
NOTE: Before you can configure a live filter, you must record at
least one image from the camera. Until an image is
recorded, the filter options are disabled.
1. Click down arrow. A list of filters appears.
2. Click the desired filter. Select None to disable any previously
configured filters.
3. Click Setup to configure the filter (see Live Filter
Configuration on page 68).
Pre-Alarm Duration — The unit continuously saves pre-alarm
images for each camera, up to the pre-alarm duration. When an
event occurs, the unit records these images to the image database.
The default is 15 Seconds.
1. Click down arrow. A list of options appears.
2. Click the desired pre-alarm duration.
Setup — Select a filter for this segment; then click Setup to
configure it (see Live Filter Configuration on page 68).
To Next Page
Loading...
