Installation and Operating Instructions 31
Cameras Setup
CAMERAS SETUP
The Cameras Setup screens let you define the name and
termination settings for each camera. You must possess the Setup
Cameras privilege to access it (see Security Setup on page 39).
1. From the main screen, click the Setup button. The Setup
Options screen appears (see Setup Options Screen on page 29).
2. Click the Cameras button. The Names screen (the first
Camera Setup screen) appears.
Use the Names tab to define the name of each camera. These names
are displayed when viewing live images and are stored in the image
database with recorded images.
Names Tab
1–16 — Use the mouse pointer to highlight one of the current
camera names. Then use the virtual keyboard or the physical
keyboard (if attached) to enter the new name, up to 10 characters.
The default names are Camera1 through Camera16.
Click OK to accept the new camera names, as well as any changes
on the other Camera Setup screen. Click Cancel to cancel the
changes. Click Help to display online help for this screen.
Termination Tab
Since terminators are not required on Intellex units, use the
Termination screen to define each camera’s setting, either 75 Ohms
or Hi-Z. The default is 75 Ohms.
When set to 75 Ohms, the unit terminates the camera. This is the
same as installing a terminator on the associated Camera Out
connector.
When set to Hi-Z, the camera signal is passed through to the
associated Camera Out connector. This is the same as removing a
terminator and attaching a cable to the associated Camera Out
connector.
Camera Control Tab
1. From the main screen, click the Setup button. The Setup
Options screen appears.
2. Click the Cameras button and click the Camera Control tab.
3. For each of the cameras to be controlled, select a camera
handler from the pull down menu:
•Select TT16 if you have a VM16 or ADTT16E Touch
Tracker or Enhanced Touch Tracker.
To Next Page
Loading...
