Installation and Operating Instructions 179
Installation and use of Intellex Accessories
If the USB Port Expander
drivers are already installed in
Intellex
DV8000 and DV16000 units with product codes D80024x-xxx and
D60024x-xxx already have the USB port expander drivers installed.
Installation
Insert the USB cable of the port expander into one of the USB
connectors in the rear of the Intellex. It is not necessary to exit
Intellex.
Intellex Speakers-
RDVSPK01
The Intellex Speakers can be used to listen to recorded audio
information or to monitor live audio activity.
Installation
Follow the directions provided with the speakers to connect the
speakers together and to the power source. Then insert the mini
phone plug into the green audio output jack on the rear of the
Intellex. Use the Audio Setup functions in Intellex to adjust the
volume as required.
Intellex Serial Interfaces
and Text Recording
Internal COM ports Intellex units with version 2.1 hardware or later have only one
external serial port. It should be configured as COM 2 and is
dedicated to the Touch Tracker interface. (The motherboard BIOS
parameters for COM 2 are I/O Address=2F8, Interrupt=IRQ3).
Any additional serial ports must be added by means of a USP serial
port expander.
Port Expanders The serial port expander supported by Intellex is the Edgeport/4 by
Inside Out Networks. The Sensormatic part number is RDVEXP01.
The Edgeport/4 driver is already installed on DV16000 systems
manufactured with version 2.5 software.
Port Assignments The serial port assignment is made by the Edgeport driver. It
assigns COM ports based on the serial number of the port expander.
This means that if you plug one port expander in and it is assigned
serial port numbers COM 3-6, and you remove it and plug in
another port expander, it will then be assigned serial port numbers
COM 7-10. Always keep the same port expander with the same
Intellex. If you switch Edgeports, you must then renumber the
COM port setup in Intellex.
To Next Page
Loading...
