Installation and Operating Instructions 11
Installing the Intellex Unit
INSTALLING THE
INTELLEX UNIT
Select a location for the unit that is clean and dry and where
temperature and humidity extremes do not exceed the product
specifications (see Technical Specifications on page 183). Failure to do
so can result in equipment failure and loss of warranty protection.
Make sure the location has stable AC power for the unit. Protect the
unit against severe power fluctuations by installing surge
protection devices on all power cables.
Required Connections
Cameras In CAUTION: Protect the unit against lightning. If a portion of a
cable is installed outside of a building, the entire
cable is vulnerable to lightning. Therefore, install
surge protection devices on all vulnerable cables.
Connect the video output of each camera or other composite video
source to its corresponding Camera In connector (the left of each
pair of BNC connectors). To use the passive loop through feature,
see Cameras Out on page 11.
Monitor The monitor displays live and recorded cameras, as well as system
configuration and status information.
Power Setting CAUTION: Before connecting power, set the voltage switch
to the correct voltage (“115” or “230”).
Switch the power supply to the correct input voltage setting: 115 or
230 volts.
Power In CAUTION: You may want to install power line conditioning
equipment to protect the unit against severe power
fluctuations.
CAUTION: Do not apply power until you have connected all
optional items.
Connect the power cable to the unit.
Mouse Connect the mouse (or other pointing device) to the Mouse
connector.
Optional Connections
Cameras Out The Camera Out connectors pass through the live video signal
from the Camera In connectors.
To Next Page
Loading...
