Installation and Operating Instructions 79
Alarms Setup
Latch Messages — Use this option to require the operator to
manually clear every alarm using the Clear Latched button on the
Utility Options screen. Otherwise, alarm messages remain on the
screen until either the duration time expires or the event is cleared.
Unit Alarm Out — Use this option to energize alarm output 16
whenever any alarm event occurs. Otherwise, the unit only
energizes alarm output 16 whenever an alarm event occurs on
camera 16.
Message Alert — Use this option to energize alarm output 16
when:
• The unit is in linear mode and a notification screen appears;
or
• The unit is background archiving and a notification screen
appears.
NOTE: The Alarms indicator on the front panel flashes in either
situation and cannot be disabled.
Quality — Select the record quality to use when an alarm occurs.
The default setting is Normal.
Super — Record images at the highest image quality. Since the
unit uses the lowest level of compression, this setting requires
the highest amount of storage space.
Normal — Record images at normal image quality. This
setting provides a balance between compression and storage
space requirements.
Extended Record — Record images at the highest level of
compression. This setting requires the lowest amount of
storage space.
Sensitivity — This setting lets you control how Intellex responds
to small, subtle changes between images. Select the sensitivity to
use during an alarm event. The default is Normal.
High — At this setting, Intellex records the smaller changes
between images, improving the perceived picture quality. As a
result, this setting requires more storage space.
Normal — At this setting, Intellex ignores the smaller, more
subtle changes between images
To Next Page
Loading...
