Installation and Operating Instructions 131
Image Database Search
This option can be set from five seconds to 10 minutes. The default
is 00:05 (five seconds).
1. Click the minutes display.
2. Click up arrow or down arrow to display the correct minutes
(1–10).
3. Click the seconds display.
4. Click up arrow or down arrow to display the correct number
of seconds (five-second increments).
NOTE: When searching the database, the unit may skip a few
seconds more or less than the setting.
Filter — Use this option to select the filter for searching the image
database. The default is None.
NOTE: Before you can configure a search filter, you must record
at least one image from the camera. Until an image is
recorded, the filter options are disabled.
5. Click down arrow. A list of filters appears.
6. Click the correct filter.
7. Click Setup to configure the filter (see Search Filter
Configuration on page 132).
Setup — Select a filter for this search; then click Setup to configure
it (see Search Filter Configuration on page 132).
Select the Mode or Date/Time tab to define a search for a specific
video segment.
Find — Click to start the search using the entered search criteria.
As soon as a search is started:
• Τhe unit erases any previous search results from the screen
• Τhe search icon moves while the unit is searching
• Τhe unit lists matching video segments as they are found
Stop — Click to interrupt the search process. The unit lists all
video segments that it found before the interruption.
To Next Page
Loading...
