74 Intellex
®
LT Digital Video Management System
Schedule Setup
NOTE: The pointer changes to if it is dragged to an invalid
location.
c. Click the mouse button to lock this boundary and start a new
one.
d. Repeat these steps until you are ready to enclose the target
area.
e. Use one of the following methods to enclose the target area:
• Set at least three endpoints. Then hold the mouse pointer
over the last endpoint and double-click the button. The
boundary lines disappear and the target area is defined
by a semitransparent grid.
• Move the mouse pointer to the starting point and click
the mouse button. The boundary lines disappear and the
target area is defined by a semitransparent grid.
Click Apply to apply the configuration for this filter as shown and
close the Perimeter Protection screen. Click Cancel to cancel the
changes and return to the previous screen. Click Help to display
online help for this screen.
To Next Page
Loading...
