User Manual – Rev BE AMETEK Programmable Power
MX Series 103
The WAVEFORM screen is used to select a user defined
arbitrary waveform. (3Pi controller only)
MEAS The MEAS key is a shortcut to access the
MEASUREMENT screen directly. The MEASUREMENT
screen is one of the most frequently used screens.
Thus, instead of going through the main menu to reach
the MEASUREMENT screen, it can be accessed directly
by pressing the MEAS key.
OUTPUT ON/OFF The OUTPUT ON/OFF key toggles the output relay on or
off. The state of the output relay is reflected by the
green LED located directly to the left of the OUTPUT
ON/OFF key. If the green LED is lit, the output relay is
enabled (closed) and the programmed output voltage is
present at the output terminals. If the green LED is off,
the output relay is open and both the HIGH and LO
terminal of the output terminal block are disconnected
from the power source. In this mode, the output is
floating. The ON/OFF button provides a convenient way
to disconnect the load without having to remove any
wires.
PHASE The PHASE key is used to select the phase on a MX30-
3Pi or MX45-3Pi model. Pressing the PHASE key will
toggle phase A, B, C or ABC. Some screens may not
support the ABC or show all phase information in which
case this mode is skipped. (3Pi controller only)
SET The SET key is used to select the mode of operation of
the shuttle. Refer to section 4.1.1 for details on its
operation and the use of the SET key.
+/- The +/- key can be used to toggle the sign for those
parameters for which it is relevant. This is typically the
output voltage when in DC mode of operation. For
fields that have only two possible values such as the
voltage range field, the +/- key can be used to toggle
between these two values.
To Next Page
Loading...
Need help?
General
