User Manual – Rev BE AMETEK Programmable Power
MX Series 114
• by pressing the PROG key in the FUNCTION keypad
The PROGRAM menu is used to change output parameters. The most used
parameters are all located in PROGRAM 1. The PREVIOUS SCREEN entry, when
selected, will return the user to the most recently selected menu. This is
normally the MENU screen unless the PROGRAM menu was selected using the
PROG key on the FUNCTION keypad. Less frequently used parameters are in
PROGRAM 2, which can be reached from the PROGRAM 1 screen using the
MORE selection, or by pressing the PROGRAM key twice.
The following choices are available in the PROGRAM menus:
Entry Description
PROGRAM 1
VOLTAGE Programs the output voltage in Vrms while in AC mode
or absolute voltage when in DC mode. In DC mode,
negative values can be entered.
FREQ Programs the output frequency when in AC mode. If the
unit is in DC mode, the value for FREQ will be set to DC
and cannot be changed until AC mode is selected.
When in AC mode, the frequency can be changed from
16 Hz to 500 Hz. Values entered that fall outside this
range will generate a -200 RANGE ERROR and will not
be accepted.
VOLT RANGE Selects 150V, 300V or optional 400V range in AC mode
and 200V or 400V range in DC mode. The actual range
values may be different depending on the configuration.
The value of this field can only be changed with the
shuttle or the +/- key.
CURR LIMIT Sets the current limit value for the current detection
system. When the load current value exceeds the set
current limit, a fault condition is generated. The actual
response of the AC Source to a current limit fault is
determined by the protection mode selected in the
CONFIGURATION menu. (CC = Constant Current, CV =
Constant Voltage).
PROGRAM 2
PHASE Selects the phase angle between the external clock and
the output of the AC source. If the clock source is
internal, this parameter has no effect.
To Next Page
Loading...
Need help?
General
