User Manual – Rev BE AMETEK Programmable Power
MX Series 153
Note that the fourth configuration screen is only available on MX models with
firmware revision 4.60 or higher. For units with older models, refer to the
CONFIGURATION SETUP 3 screen.
MB This entry was moved from CONFIGURATION SETUP 3
to CONFIGURATION SETUP 4. Its purpose remains the
same. For details, see CONFIGURATION SETUP 3
manual section on previous page.
MANUAL This field does not apply to MX products and is always
set to N/A.
OPT0, OPT1, OPT2 This field indicates the presence of the following three
options:
OPT0 = A350 Avionics option (-A350)
OPT1 = AMD24 Avionics option (-AMD)
OPT2 = B787 Avionics option (-B787)
The scroll through the three available OPTn fields, use
the shuttle. ON indicates the option is present, N/A
indicates the option is not installed.
LAN This field indicates the presence of the LAN Ethernet
interface option. ON indicates the option is present, N/A
indicates the option is not installed.
SNK This field indicates the presence of the Current Sink
regenerative mode option. ON indicates the option is
present, N/A indicates the option is not installed.
FC This field, when ON, indicate the presence of the
frequency control option. This option will cause the
frequency to fluctuate ±0.25% of the program value.
To Next Page
Loading...
