7-28
129390199 Operator Manual Cycle and Control Value Programming
3. At machine number screen, enter a two-digit code for the
sterilizer using the entry keypad. Ensure, however, that each
machine number used is different from any others that have
been assigned in the facility.
4. If an incorrect value is entered, press the backspace key to clear
the entry, then use the keypad to enter the correct value.
5. Press Exit to abandon changes and return to the Machine Setup
screen.
OR
Press OK to save machine number and return to Utility Control
screen.
To Next Page
Loading...
Need help?
General
