Amsco Evolution Series - Change Time and Date; Set Time Format

7-8
129390199 Operator Manual Cycle and Control Value Programming
7.4 Change Time and
Date
These screens adjust the time and date the sterilizer uses for all
display and printout messages.
The current time and date appears on the Standby and Cycle Status
screens. Time and date are also shown on printouts. These should
be verified periodically.
To change:
1. At Options screen, press Set Date and Time touch pad.
The display advances to Change Time/date screen.
2. Make adjustments using procedures shown below:
7.4.1 Set Time Format This option allows the operator to select time display “format." Format
determines how hours and minutes are displayed. There are two
options — the default format shows time in the military format
(referred to as 24 HOUR); the optional format shows time in AM/PM
format.