Amsco Evolution Series - Cycle and Control Value Programming; Change Values; Change Cycle Values; Change Time and Date

7-1
Cycle and Control Value Programming Operator Manual 129390199
AMSCO
®
Evolution
®
Series Steam Sterilizers are shipped with
factory-set cycles, cycle values and control values programmed into
the control (see Table 7-1). These preset values can be changed to
tailor the sterilizer to the operating environment in which it has been
installed. To change these values, refer to S
ECTION 7.3.2, CHANGE
CYCLE VALUES PROCEDURE, PAGE 7-6.
Important: Applicable cycles have been validated to satisfy the
requirements outlined in Table 1 (page ii) and Table 2 (page iii). If
cycle parameters (sterilize time or dry time) other than those in
Table 7-1 are required, it is the responsibility of the healthcare
facility to consult and follow the device manufacturer’s written
instructions.
CYCLE AND
CONTROL VALUE PROGRAMMING
7