7-4
129390199 Operator Manual Cycle and Control Value Programming
7.2 Change Values Important: Applicable cycles have been validated to satisfy the
requirements outlined in Table 1 (page ii) and Table 2 (page iii). If
cycle parameters (sterilize time or dry time) other than those in
Table 7-1 are required, it is the responsibility of the healthcare
facility to consult and follow the device manufacturer’s written
instructions.
The Change Values procedure described in the following pages can
be used to adjust cycle values within a limited range and to make
selections affecting the operating style of the unit. Refer to Table 7-1
for cycle values.
The Change Values Procedure can be used to adjust the following
values:
Sterilization Exposure Temperature
Important: Sterilization temperature is limited to certain values, refer
to S
ECTION 7.3, CHANGE CYCLE VALUES, PAGE 7-5.
Sterilization Exposure Time
Important: Sterilize time is limited to a predetermined range of
values, refer to S
ECTION 7.3, CHANGE CYCLE VALUES, PAGE 7-5.
Dry Time
Important: Dry time is limited to a predetermined range of values,
refer to S
ECTION 7.3, CHANGE CYCLE VALUES, PAGE 7-5.
Other Information
• Change Values can also be used to make adjustments to the
Machine Setup values shown on Table 7-4.
• Default cycle values are shown on Table 7-1.
• Change Values screens are accessed by pressing Change
Values button on Options screen.
To Next Page
Loading...
Need help?
General
