Amsco Evolution Series - SFPP Sterilizer Cycles

6-25
Sterilizer Operation Operator Manual 129390199
6.12 SFPP Sterilizer
Cycles
AMSCO Evolution Series SFPP Steam Sterilizers are shipped with
factory-set cycles. The cycle sequence for these cycles is given in
S
ECTION 6.12, SFPP STERILIZER CYCLES, on PAGE 6-25. Refer below,
and to Table 6-2 and Table 6-3 for factory-set, qualified cycle
settings.
Important: The sterilization cycles listed in Table 6-11 have been
validated using techniques documented in AAMI ST-8. If different
cycle parameters (sterilize time and dry time only) other than those in
Table 6-2 and Table 6-11 are required, it is the responsibility of the
healthcare facility to consult and follow the device manufacturer’s
written instructions.
NOTE: Contact your Customer service representative for information
on a wide range of education/training programs designed to meet the
educational needs of healthcare industries.